Do you take on finishing as a separate package?

Yes — within general contracting or as a separate package; each finishing item and its materials are set out in the offer from the drawings and specification.

What do your finishing works include?

Interior finishes through turnkey handover, floors (epoxy with marking and numbering), microcement, protective and decorative coatings, and facade, glazing and aluminium finishes; each item and its materials are set out in the offer from the drawings and specification.

Why must the waterproofing be finished before the finishes?

Because tiles, floors and ceilings cover the waterproofing, and any defect found afterwards means breaking the finish. So wet-area and roof details are completed, flood-tested and accepted before finishing works start over them.

▽ +03.00Pillar 02 · Finishing

Fit-Out & Finishing

From design intent to the final finish: surface preparation, materials, execution and the details that make the difference.

Overview Layer by layer Six stages What we finish FAQ

Overview

Finishing as part of protection

Finishing is what people see of a building — and it is also where protection layers are most often damaged: a fixing through a bathroom membrane, tiles laid over an untested roof. So we treat finishing as a continuation of the protection works: a prepared surface, materials suited to their location, and details that do not cut the layers below.

Our scope covers interior finishing through turnkey handover, epoxy floors, microcement and protective coatings, and facade works; the exact items for each project are set out in the offer.

Epoxy floor with yellow line marking and a drainage channel

From raw to finished

What happens to a surface before you see it

01
Raw structure
Concrete as it was left after the pour.
Material sampleConcrete as poured
02
Surface preparation
Defects repaired, levelled and mechanically prepared.
Material samplePrepared surface
03
Finish application
Primer, then the coats at the specified thickness.
Material sampleFinish coat
04
Final result
A uniform surface, protected until handover.
Material sampleFinished surface

Next step

A finishing project?

Send the drawings, specification and finishes schedule for an itemised offer with materials.

Send your finishes schedule Ask for a technical consultation WhatsApp

Fit-Out & Finishing

Finishing as part of protection

What happens to a surface before you see it

Raw structure

Surface preparation

Finish application

Final result

Layer by layer: the finish in section

Sample: epoxy floor

Sample: microcement

Six stages for every finish

Design intent

Preparation

Materials

Execution

Detailing

Final finish

What we finish

Interior finishes

Floors

Microcement

Protective & decorative coatings

Facade finishes

Questions

A finishing project?

Ask Prime Shield Engineer